콘텐츠로 이동

CT-UART-001 Test Result

Go Back to the Pytest TEST All Index


Test summary


Item Value
Description test_uart_timing
Category timing
Environment local
Result PASS
Execution time 0.001 seconds
Execution date 2026-08-19T11:54:40.248089+09:00
Execution ID 20260819_115440_247993


Test configs


Test Item Value
Test ID CT-UART-001
Category timing
Fixture ID FIXTURE-001
Fixture mode mock


FIXTURE-001 Value
Interface UART
Equipment Saleae
Equipment mode mock
Interface mode mock

Test Source


Item Value
Commit 586c4796f0ade0165d217e53f4afb4a6def79c48
Branch main


Measurement


Item Value
expected_baudrate 921600
measured_baudrate 921596.667
error 3.6168981481902543e-06
jitter 0.00021701388888888888


Statistics


Item Value
mean 921596.6666666666
median 921602.5
min 921490.0
max 921690.0
stddev 67.55656066503748


Logs


  • Path:
    test_reports/results/pytest/test_cases/CT-UART-001


Item Value
Test log 20260819_115440_247993_test.log
Test Result 20260819_115440_247993_result.json


Local LLM Analysis


Item Value
Classification Pass
Confidence 0.95
Analyzer ollama/deepseek-r1:7b
Status enabled


LLM Test Prompt


analyze the test result and provide a detailed report with recommendations for improvement.


Test Result


Item Value
Status PASS
Severity LOW
Warnings 0
Needs Escalation OFF


Test Summary


Item Value
Summary The test for CT-UART-001 in category 'timing' has completed with all tests passing. The measured baudrate of 921596.667 is very close to the expected 921600, with a small error of 3.6e-6 and low jitter of 0.000217. The test execution time was 0.00059 seconds, indicating efficient performance. No errors, warnings, or logs were observed during the test.
Failure Analysis No failure detected in the test execution.
Source Review The test source code and configurations appear to be correctly implemented without any discrepancies. The test environment settings are consistent with the intended setup.
Warnings None
Recommendations Review the baud rate calculations and clock sources to ensure they are not introducing jitter. Consider implementing margin checks on the baud rate to handle minor variations gracefully.